The tube from the bottom of the float bowl should be the drain for the bowl. It doesn't attach anywere. Just make sure the valve on it is closed.

Jamie

Thanks. I found the problem. I lost the metal pin that holds the float in place. I reinstalled the pin and it fixed the problem.

This site rocks.

I took the liberty of creating a .PDF document out of Hopsters re-jetting instruction (with a few of THEBLADE_GUY’s pictures and will try to post them here. I hope no one objects. And thanks guys, this is exactly the type of instructions a newbie like me needs.

Excellent...

Pictures with jet in and jet out, you may want to say All Jets In and Main Jet Removed, as there are other jet circuits in the picture as well.


Step 10 should read:

Adjust idle speed setting, and idle speed airbleed screw as the required settings were likely altered.


Good job,

Steve

I'll edit the .pdf file on monday when i get back to my office if that is ok. Any other changes you would like to see..just let me know..and i'll get them all at once. I think lots of poeple will get use out of your information. Thanks for your work.

Sweet work Neal! Thanks for the guide!

Thanks man!

Made a few changes in the wording in the .PDF file, so here is the updated version.

Note: All credit goes to Hopster and THEBLADE_GUY. I am just the computer nerd who put the instructions in a .PDF document. (So I can print the guild and put my grease covered computer hands on it when I get confused).

Awesome. Thanks again, this is a great contribution to the site!

-Steve

wow you guys have done great, this will help me a ton being that i am a visual learner thanks again...............