I just bought an 07 joyner sand viper 250 it needs ball joints but I dont know where to get them can anyone help?

Contact Glade (doonrnr) or Joyner USA. I live in Vegas an recieve parts from Joyner in 1-2 days.

Greg

Yup....just let me know what you need and we can get you fixed up.

Glade
EDGE Powersports

Thanks guys!

Right now im in need of the front drivers side upper ball joint ( I might however just go ahead and replace all 4 both upper and lower right and left) and also in need of the speed sensor.

Im ahaving a problem with my rear brakes so im not sure just yet but I might need the master cylinder (my rear brakes are NOT working and we try and bleed them and start to get pressure but after a while we lost all presurre for the rear which is causing them not engage, Not quit sure yet whats going on here I'm going to hook them up to a pump in order to pump out any air to see if this works)

getting into these buggies huh

have you seen the socal buggy bash knew you were asking about it i sent you a pm and there is a link in my sig

Do you have a picture of your machine? Just curious.....because the SV 250 does not have ball joints to speak of. End bearings and joint bearings.....

Glade

i am pretty sure it has the same joints that mine has on the front

No they look different to me here it is

More photos of 2007 joyner sand Viper

You need the following parts:

304.1-GE20C - JOINT BEARING GE20C
893.2-φ35 - HOLE RETAINOR RING 35