What do you do with the vacuum lines if you convert to a manual petcock.?

You will run the vacuum line directly from the intake elbow to the carburetor vacuum slider with no tee fittings. If you eventually go to a slide carburetor, you will completely block the vacuum line at the elbow.

You will run the vacuum line directly from the intake elbow to the carburetor vacuum slider with no tee fittings. If you eventually go to a slide carburetor, you will completely block the vacuum line at the elbow

Just to clarify because I'm not very good with engines. I will eliminate the hose that comes out of the tank and just connect the other 2 with out the "T"?
Again I want to tell everyone that has helped me that this forum is awesome and I can't beieve how generous peoploe are with their time and knowledge. I've already ordered some performance parts from 1 dealer on this site and will always look to the sponsors of this site first.

when you go with a manual valve, the hose that comes off the intake will then go straight to the passenger side of the carb where the barb is