I'm not totally sure, but I am pretty sure it jerks less now, which makes me happy enough.

And yes, it helps to get a little bit of axle experience in. It's not too bad, just getting the bearings out of their fitting was the only tricky thing.

The bearings went in alright. I did some light tapping going around the outside of the bearing with a plastic-type hammer, so that went fine. Getting the old ones out was slightly challenging. I had to beat it with the hammer pretty hard.

I'll definitely clean out the cvt to see if that helps any. I haven't been in there in a while since the clutch has been working well. I also may need to tighten the chain just a little bit.

We'll see though, it just takes a lot of tinkering and messing around.