BuggyNews Buggy Forum http://buggynews.com/
Replacement Motor for Hammerhead 200 http://buggynews.com/replacement-motor-for-hammerhead-200-t15760.html	Page 1 of 2

---

Author:	BACNBLK [ Tue Nov 18, 2008 9:11 am ]
Post subject:	Replacement Motor for Hammerhead 200
My son has Orange Hammerhead 200. I am in search of a replacement engine. Can anyone ponit me in the right direction?

---

Author:	BIGE [ Tue Nov 18, 2008 9:19 am ]
Post subject:
whats the matter with the engine? does it need rings?

---

Author:	BACNBLK [ Tue Nov 18, 2008 9:24 am ]
Post subject:
Piston, Rings, Etc. Upper end. Bottom end? Dont know enough about it to rebuild it. I am told a 150 GT motor will not fit in it because of mounts?

---

Author:	BIGE [ Tue Nov 18, 2008 9:34 am ]
Post subject:
I think it will fit, the 200 is just a model# tj used when they were trying to make a 200cc engine. was it just smoking alot or did it make a knocking sound?

---

Author:	BACNBLK [ Tue Nov 18, 2008 9:41 am ]
Post subject:
Piston is scarred, cylinder wall scarred, wrist pin blue. Looks like it lost oil to upper end.

---

Author:	BIGE [ Tue Nov 18, 2008 10:18 am ]
Post subject:
you could put a 155 kit on it if there is not any metal in the oil screen

---

Author:	BACNBLK [ Tue Nov 18, 2008 3:28 pm ]
Post subject:
How do I identify motor to order parts? Is there a model # stamped on motor some where.

---

Author:	BIGE [ Tue Nov 18, 2008 3:38 pm ]
Post subject:
there is a series of numbers on the lower left side of the case. it should be a standard gy6 with internal reverse

---

Author:	BACNBLK [ Wed Nov 19, 2008 1:08 pm ]
Post subject:
Heres What I found: TJPS On side of Case These Numbers are on the bottom: 157QMJ *07010062*

---

Author:	BIGE [ Wed Nov 19, 2008 1:13 pm ]
Post subject:
if there is not alot of metal in the oil then you could go with a 155 kit, new cylinder, piston, rings, pin and clips

---

Page 1 of 2	All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/