Joined: Tue Feb 10, 2009 4:03 am Posts: 32 Location: Queen Creek, AZ
Okay, I had a master cylinder go out on me, I couldnt get any pressure to any of my brake calipers. So I ordered one from Edge Powersports and when I went to go bench bleed it everything seem to go good untill I noticed that one of the hoses had no fluid coming out of it. So I decided to hook up my vacuum bleeder to that hose and see if I could possible get any fluid out of it. When I started to pump my vacumm bleeder nothing came out. I was at it for 5 min. hoping that something would come out.
So would i be right to assume (and yes i know what it means to assume) that that side of the cylinder is not working? It is the side with the brake light hook up. Both the other sides had a good stream of fluid comming out of them.
_________________ '07 250cc Kinroad Shorty Clutch Kit 15g Sliders Blue Main Spring UNI filter FMF Exhaust 132.5 jet
Joined: Wed Dec 19, 2007 12:45 pm Posts: 3777 Location: Maricopa Az
Hi, pull the brake light switch and see if fluid comes out there. Look for debrey,filling,somtimes on new cylinders they don't get them clean after machining.Ghost
Joined: Tue Feb 10, 2009 4:03 am Posts: 32 Location: Queen Creek, AZ
I talked to Glade and he is going to send me a new one . So I am going to wait for that one to come in and start from the begining and hope for the best.
_________________ '07 250cc Kinroad Shorty Clutch Kit 15g Sliders Blue Main Spring UNI filter FMF Exhaust 132.5 jet
Users browsing this forum: No registered users and 1 guest
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum